Cash for Your Remotes Programming instructions for Automotive Keys, ChipKeys and Transponder Keys.
PrintPrint
These programming procedures are only good for USA built vehicles.

The first digit of your 17 digit VIN number must start with the number 1 or 4.

If your VIN number starts with a 2 or 3 or a letter these procedures WILL NOT WORK.


Can I program a new key myself if I have no working keys?
  
    
Yes, once you have had the new key cut by a Locksmith
     or other qualified persons use the following instructions.

     
Click here to find a Locksmith in your area

1.  Insert new key into ignition cylinder and turn it to the ON position.
     (As far as you can go without cranking engine)
     The security light on the dash will illuminate and stay on for ten minutes.
     When the security light goes out, you have one minute to start the next step.

2.  Turn the ignition cylinder to OFF and then back to the ON position.
     The security light on the dash will illuminate and stay on for ten more minutes.
     When the security light goes out, you have one minute to start the next step.

3.  Turn the ignition cylinder to OFF and then back to the ON position.
     The security light on the dash will illuminate and stay on for ten more minutes.

4.  After the security light has gone off for the third time, turn key off and remove
     from ignition. The key is now programmed and all other keys have been erased.

5.  Insert key and start vehicle to test key.



Can I program a duplicate key for this vehicle?

   Yes, once you have had the new key cut by a Locksmith
    or other qualified persons use the following instructions.

    Click here to find a Locksmith in your area

1.  Insert  an existing programmed working key into the ignition cylinder.    
    
2.  Turn ignition to the ON position and back to OFF

3.  Remove the existing key and within 10 seconds insert new key and
     turn it to the ON positiion.

4.  The security light will light up for 2 seconds to indicate successful
     programming of the addtional key. Remove key from ignition.

5.  Insert key and start vehicle to test key.


     Disclaimer


PrintPrint These Instructions
Copyright © 2014 ProgramAutoKeys.com. All Rights Reserved.